Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 411)

Brocade 6910 Ethernet Access Switch Configuration Guide 361
53-1002581-01
ERPS Commands
19
Related Commands
enable (362)
erps domain
This command creates an ERPS ring and enters ERPS configuration mode for the specified domain.
Use the no form to delete a ring.
Syntax
[no] erps domain name
name - Name of a specific ERPS ring. (Range: 1-12 characters)
Default Setting
None
Command Mode
Global Configuration
Command Usage
Up to 6 ERPS rings can be configured on the switch.
Example
Console(config)#erps domain r&d
Console(config-erps)#
control-vlan
This command specifies a dedicated VLAN used for sending and receiving ERPS protocol
messages. Use the no form to remove the Control VLAN.
Syntax
[no] control-vlan vlan-id
vlan-id - VLAN ID (Range: 1-4093)
Default Setting
None
Command Mode
ERPS Configuration
Command Usage
• Configure one control VLAN for each ERPS ring. First create the VLAN to be used as the control
VLAN (
vlan , page 379 ), add the ring ports for the east and west interface as tagged members
to this VLAN ( switchport allowed vlan , page 382 ), and then use the control-vlan command to
add it to the ring.