Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 125)

Brocade 6910 Ethernet Access Switch Configuration Guide 75
53-1002581-01
Line
5
Line
You can access the onboard configuration program by attaching a VT100 compatible device to the
server’s serial port. These commands are used to set communication parameters for the serial
port or Telnet (i.e., a virtual terminal).
line
This command identifies a specific line for configuration, and to process subsequent line
configuration commands.
Syntax
line {console | vty}
console - Console terminal line.
vty - Virtual terminal for remote console access (i.e., Telnet).
Default Setting
There is no default line.
TABLE 17 Line Commands
Command Function Mode
line Identifies a specific line for configuration and starts the line
configuration mode GC
accounting exec Applies an accounting method to local console, Telnet or SSH
connections LC
authorization exec Applies an authorization method to local console, Telnet or SSH
connections LC
databits * Sets the number of data bits per character that are interpreted and
generated by hardware LC
exec-timeout Sets the interval that the command interpreter waits until user input is
detected LC
login Enables password checking at login LC
parity * Defines the generation of a parity bit LC
password Specifies a password on a line LC
password-thresh Sets the password intrusion threshold, which limits the number of
failed logon attempts LC
silent-time *
* These commands only apply to the serial port.
Sets the amount of time the management console is inaccessible after
the number of unsuccessful logon attempts exceeds the threshold set
by the
password-thresh command
LC
speed * Sets the terminal baud rate LC
stopbits * Sets the number of the stop bits transmitted per byte LC
timeout login response Sets the interval that the system waits for a login attempt LC
disconnect Terminates a line connection PE
show line Displays a terminal line's parameters NE, PE