Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 1096)

1046 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
Displaying the Routing Table
44
• The Routing Table (and show ip route command) only displays routes which are currently
accessible for forwarding. The router must be able to directly reach the next hop, so the VLAN
interface associated with a static route entry must be up. Note that routes currently not
accessible for forwarding, may still be displayed by using the
show ip route database
command.
Parameters
These parameters are displayed in the web interface:
• VLAN – VLAN identifier (i.e., configured as a valid IP subnet).
• Destination IP Address – IP address of the destination network, subnetwork, or host.
Note that the address 0.0.0.0 indicates the default gateway for this router.
• Net Mask – Network mask for the associated IP subnet. This mask identifies the host address
bits used for routing to specific subnets.
• Next Hop – The IP address of the next hop (or gateway) in this route.
• Metric – Cost for this interface. (Not applicable for current phase.)
• Protocol – The protocol which generated this route information. (Options: Local, Static)
Interface
To display the routing table:
1. Click IP, Routing, Routing Table.
FIGURE 340 Displaying the Routing Table