Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 653)

Brocade 6910 Ethernet Access Switch Configuration Guide 603
53-1002581-01
IPv6 Interface
29
Example
This example assigns a dynamic global unicast address of
2001:DB8:2222:7272:2E0:CFF:FE00:FD to the switch.
Console(config-if)#ipv6 address autoconfig
Console(config-if)#ipv6 enable
Console(config-if)#end
Console#show ipv6 interface
VLAN 1 is up
IPv6 is enabled
Link-local address:
FE80::2E0:CFF:FE00:FD/64
Global unicast address(es):
2001:DB8:2222:7272:2E0:CFF:FE00:FD/64, subnet is
2001:DB8:2222:7272::/64[AUTOCONFIG]
valid lifetime 2591628 preferred lifetime 604428
Joined group address(es):
FF02::1:FF00:FD
FF02::1
IPv6 link MTU is 1280 bytes
ND DAD is enabled, number of DAD attempts: 3.
ND retransmit interval is 1000 milliseconds
ND advertised retransmit interval is 0 milliseconds
ND reachable time is 30000 milliseconds
ND advertised reachable time is 0 milliseconds
Console#
Related Commands
ipv6 address (601)
show ipv6 interface (608)
ipv6 address eui-64
This command configures an IPv6 address for an interface using an EUI-64 interface ID in the low
order 64 bits and enables IPv6 on the interface. Use the no form without any arguments to remove
all manually configured IPv6 addresses from the interface. Use the no form with a specific address
to remove it from the interface.
Syntax
ipv6 address ipv6-prefix/prefix-length eui-64
no ipv6 address [ipv6-prefix/prefix-length eui-64]
ipv6-prefix - The IPv6 network portion of the address assigned to the interface.
prefix-length - A decimal value indicating how many contiguous bits (from the left) of the
address comprise the prefix (i.e., the network portion of the address).
Default Setting
No IPv6 addresses are defined
Command Mode
Interface Configuration (VLAN)