Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 275)

Brocade 6910 Ethernet Access Switch Configuration Guide 225
53-1002581-01
IP Source Guard
10
Example
Console#show ip dhcp snooping binding
MAC Address IP Address Lease(sec) Type VLAN Interface
----------------- --------------- ---------- -------------------- ---- ---------
11-22-33-44-55-66 192.168.0.99 0 Dynamic-DHCPSNP 1 Eth 1/5
Console#
IP Source Guard
IP Source Guard is a security feature that filters IP traffic on network interfaces based on manually
configured entries in the IP Source Guard table, or dynamic entries in the DHCP Snooping table
when enabled (see
“DHCP Snooping” on page 216). IP source guard can be used to prevent traffic
attacks caused when a host tries to use the IP address of a neighbor to access the network. This
section describes commands used to configure IP Source Guard.
ip source-guard binding
This command adds a static address to the source-guard binding table. Use the no form to remove
a static entry.
Syntax
ip source-guard binding mac-address vlan vlan-id ip-address interface ethernet unit/port
no ip source-guard binding mac-address vlan vlan-id
mac-address - A valid unicast MAC address.
vlan-id - ID of a configured VLAN (Range: 1-4093)
ip-address - A valid unicast IP address, including classful types A, B or C.
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-12)
Default Setting
No configured entries
Command Mode
Global Configuration
TABLE 55 IP Source Guard Commands
Command Function Mode
ip source-guard binding Adds a static address to the source-guard binding table GC
ip source-guard Configures the switch to filter inbound traffic based on source IP
address, or source IP address and corresponding MAC address IC
ip source-guard max-binding Sets the maximum number of entries that can be bound to an
interface IC
show ip source-guard Shows whether source guard is enabled or disabled on each
interface PE
show ip source-guard binding Shows the source guard binding table PE