Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 582)

532 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
CFM Commands
25
Example
This example creates a maintenance association, binds it to VLAN 1, and allows MIPs to be created
within this MA using the default method.
Console(config)#ethernet cfm domain index 1 name voip level 3
Console(config-ether-cfm)#ma index 1 name rd vlan 1 mip-creation default
Console(config-ether-cfm)#
ma index name-format
This command specifies the name format for the maintenance association as IEEE 802.1ag
character based, or ITU-T SG13/SG15 Y.1731 defined ICC-based format. Use the no form to restore
the default setting.
Syntax
ma index index name-format {character-string | icc-based}
no ma index index name-format
index – MA identifier. (Range: 1-2147483647)
character-string – IEEE 802.1ag defined character string format. This is an IETF RFC 2579
DisplayString.
icc-based – ITU-T SG13/SG15 Y.1731 defined ICC based format.
Default Setting
character-string
Command Mode
CFM Domain Configuration
Example
This example specifies the name format as character string.
Console(config)#ethernet cfm domain index 1 name voip level 3
Console(config-ether-cfm)#ma index 1 name-format character-string
Console(config-ether-cfm)#
ethernet cfm mep
This command sets an interface as a domain boundary, defines it as a maintenance end point
(MEP), and sets direction of the MEP in regard to sending and receiving CFM messages. Use the no
form to delete a MEP.
Syntax
ethernet cfm mep mpid mpid md domain-name ma ma-name [up]
no ethernet cfm mep mpid mpid ma ma-name
mpid – Maintenance end point identifier. (Range: 1-8191)
domain-name – Domain name. (Range: 1-43 alphanumeric characters)