Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 673)

Brocade 6910 Ethernet Access Switch Configuration Guide 623
53-1002581-01
Chapter
30
IP Routing Commands
To forward traffic to devices on other subnetworks, you can configure fixed paths with static routing
commands. Dynamic routing protocols that exchange information with other routers on the network
to automatically determine the best path to any subnetwork will be supported in a subsequent
release.
This section includes commands for static routing. These commands are used to connect between
different local subnetworks.
ip route
This command configures static routes. Use the no form to remove static routes.
Syntax
ip route destination-ip netmask next-hop [distance]
no ip route {destination-ip netmask [next-hop] | *}
destination-ip – IP address of the destination network, subnetwork, or host.
netmask - Network mask for the associated IP subnet. This mask identifies the host
address bits used for routing to specific subnets.
next-hop – IP address of the next hop router used for this route.
distance – An administrative distance indicating relative weight of a route. This weight is
used to determine the next hop router when there is more than one entry to the same
destination in the static routing table. (Range: 1-255, Default: 1)
* – Removes all static routing table entries.
Default Setting
No static routes are configured.
Command Mode
Global Configuration
Command Usage
Up to 64 static routes can be configured.
TABLE 149 Static Routing Configuration Commands
Command Function Mode
ip route Configures static routes GC
show ip route Displays specified entries in the routing table PE
show ip route database Displays static or dynamically learned entries in the routing table PE