Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 923)

Brocade 6910 Ethernet Access Switch Configuration Guide 873
53-1002581-01
Access Control Lists
41
Binding a Port to an Access Control List
After configuring ACLs, use the Security > ACL > Configure Interface (Configure) page to bind the
ports that need to filter traffic to the appropriate ACLs. You can assign one IP access list and one
MAC access list to any port.
CLI References
• “ip access-group” on page 244
• “show ip access-group” on page 245
• “mac access-group” on page 254
• “show mac access-group” on page 255
• “Time Range” on page 102
Parameters
These parameters are displayed:
• Type – Selects the type of ACLs to bind to a port.
• Port – Port identifier.
• ACL – ACL used for ingress or egress packets.
• Time Range – Name of a time range.
• Counter – Enables counter for ACL statistics.
Interface
To bind an ACL to a port:
1. Click Security, ACL.
2. Select Configure Interface from the Step list.
3. Select Configure from the Action list.
4. Select IP, MAC or IPv6 from the Type list.
5. Select a port.
6. Select the name of an ACL from the ACL list.
7. Click Apply.