Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 551)

Brocade 6910 Ethernet Access Switch Configuration Guide 501
53-1002581-01
MVR for IPv6
23
Default Setting
Displays configuration settings for all attached interfaces.
Command Mode
Privileged Exec
Example
The following displays information about the interfaces attached to the MVR VLAN in domain 1:
Console#show mvr6 domain 1 interface
MVR6 Domain : 1
Port Type Status Immediate Static Group Address
-------- -------- ------------- --------- -------------------------
Eth1/ 1 Source Active/Up
Eth1/ 2 Receiver Active/Up Disabled FF00::1(VLAN2)
Console#
show mvr6 members
This command shows information about the current number of entries in the forwarding database,
or detailed information about a specific multicast address.
Syntax
show mvr6 [domain domain-id] members [ip-address]
domain-id - An independent multicast domain. (Range: 1-5)
ip-address - IPv6 address for an MVR multicast group.
Default Setting
Displays configuration settings for all domains and all forwarding entries.
Command Mode
Privileged Exec
TABLE 119 show mvr6 interface - display description
Field Description
Port Shows interfaces attached to the MVR.
Type Shows the MVR port type.
Status Shows the MVR status and interface status. MVR status for source ports is
“ACTIVE” if MVR is globally enabled on the switch. MVR status for receiver ports is
“ACTIVE” only if there are subscribers receiving multicast traffic from one of the
MVR groups, or a multicast group has been statically assigned to an interface.
Immediate Shows if immediate leave is enabled or disabled.
Static Group Address Shows any static MVR group assigned to an interface, and the receiver VLAN.