Displaying remote meps, Figure 305 s – Brocade Communications Systems Brocate Ethernet Access Switch 6910 User Manual
Page 1047
Brocade 6910 Ethernet Access Switch Configuration Guide
997
53-1002581-01
Connectivity Fault Management
42
Displaying Remote MEPs
Use the Administration > CFM > Show Information (Show Remote MEP) page to show MEPs located
on other devices which have been discovered through continuity check messages, or statically
configured in the MEP database and verified through cross-check messages.
CLI References
•
“show ethernet cfm maintenance-points remote detail”
•
“clear ethernet cfm maintenance-points remote”
Parameters
These parameters are displayed:
•
MEP ID – Maintenance end point identifier.
•
MA Name – Maintenance association name.
•
Level – Authorized maintenance level for this domain.
•
Primary VLAN – Service VLAN ID.
•
MEP Up – Indicates whether or not this MEP is functioning normally.
•
Remote MAC Address – MAC address of the remote maintenance point. (If a CCM for the
specified remote MEP has never been received or the remote MEP record times out, the
address will be set to the initial value of all Fs.)
Interface
To show information for remote MEPs:
1. Click Administration, CFM.
2. Select Show Information from the Step list.
3. Select Show Remote MEP from the Action list.
FIGURE 305
Showing Information on Remote MEPs