Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 46)

xlvi Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
Summary of enhancements for Brocade R2.1.0.x
Summary of enhancements for Brocade R2.1.0.x
The following table describes the features introduced in R2.1.0.x.
Summary of enhancements for Brocade R2.0.2.10
The following table describes the features introduced in R2.0.2.10.
Enhancement Description
Supports SFTP file transfer Added information about using SFTP for file transfer. See “copy” on page 67 and
“Copying Files via FTP/SFTP/TFTP or HTTP” on page 653.
Supports additional privacy
encryption methods for
SNMPv3 Added AES128, AES192 and AES256 privacy encryption methods for SNMPv3.
Refer to
“snmp-server user” on page 117, “Configuring Local SNMPv3 Users” on
page 940, and “Configuring Remote SNMPv3 Users” on page 942.
Supports configuration of
LACP timeout The LACP timeout the switch waits for the next LACPDU can be configured to a
long or short interval. Refer to
“lacp timeout” on page 296 and “Configuring a
Dynamic Trunk” on page 698.
Enhancement Description
Supports adjusting the system
clock for summer time Added configuration pages and CLI commands for adjusting the system clock for
the summer time offset. See the relevant commands starting on
page 96 and
“Configuring Summer Time” on page 665.
SNMP trap manager can be
configured with IPv4 or IPv6
address SNMP trap managers can now be configured with IPv4 or IPv6 address. Refer to
“snmp-server host” on page 113 and “Specifying Trap Managers” on page 944.
IP address for a Layer 3
interface can be configured
with a network prefix The IP address for a Layer 3 interface can be configured with a network prefix in
the CLI. Refer to
“ip address” on page 590
Action and Shutdown Interval
were added to the web page
for Loopback Detection Action and Shutdown Interval were added to the web page for Loopback
Detection. Refer to
“Configuring Loopback Detection” on page 761.
Web page for displaying ACL
statistics was re-designed Configuration fields were modified, and a button to clear the hit counter was
added to the web page for displaying ACL statistics. Refer to
“Showing ACL
Hardware Counters” on page 875.
New options were added to
the web configuration page for
ERPS domains Non-ERPS Device Protection and CFM Port MEP fields were added to the web
configuration page for ERPS domains. Refer to
“ERPS Ring Configuration” on
page 964.