Snmp-server group – Brocade Communications Systems Brocate Ethernet Access Switch 6910 User Manual
Page 166
116
Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
SNMP Commands
6
snmp-server group
This command adds an SNMP group, mapping SNMP users to SNMP views. Use the no form to
remove an SNMP group.
Syntax
snmp-server group groupname
{v1 | v2c | v3 {auth | noauth | priv}}
[read readview] [write writeview] [notify notifyview]
no snmp-server group groupname
groupname - Name of an SNMP group. (Range: 1-32 characters)
v1 | v2c | v3 - Use SNMP version 1, 2c or 3.
auth | noauth | priv - This group uses SNMPv3 with authentication, no authentication, or
with authentication and privacy. See
“Simple Network Management Protocol”
for further information about these authentication and encryption options.
readview - Defines the view for read access. (1-32 characters)
writeview - Defines the view for write access. (1-32 characters)
notifyview - Defines the view for notifications. (1-32 characters)
Default Setting
Default groups: public
1
(read only), private
2
(read/write)
readview - Every object belonging to the Internet OID space (1).
writeview - Nothing is defined.
notifyview - Nothing is defined.
Command Mode
Global Configuration
Command Usage
•
A group sets the access policy for the assigned users.
•
When authentication is selected, the MD5 or SHA algorithm is used as specified in the
command.
•
When privacy is selected, the DES 56-bit algorithm is used for data encryption.
•
For additional information on the notification messages supported by this switch, see the
Brocade 6910 Ethernet Access Switch MIB Reference. Also, note that the authentication,
link-up and link-down messages are legacy traps and must therefore be enabled in conjunction
with the
command.
Example
Console(config)#snmp-server group r&d v3 auth write daily
Console(config)#
1. No view is defined.
2. Maps to the defaultview.