Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 591)

Brocade 6910 Ethernet Access Switch Configuration Guide 541
53-1002581-01
CFM Commands
25
Frame Loss : 137
CC Packet Statistics : 647/1
Port State : Up
Interface State : Up
Crosscheck Status : Enabled
Console#
TABLE 127 show ethernet cfm maintenance-points remote detail - display
Field Description
MAC Address MAC address of the remote maintenance point. (If a CCM for the specified remote
MEP has never been received or the remote MEP record times out, the address will be
set to the initial value of all Fs.)
Domain/Level Maintenance domain and level of the remote maintenance point
MA Name Maintenance association to which this remote MEP belongs
Primary VLAN VLAN to which this MEP belongs
MPID MEP identifier
Incoming Port Port to which this remote MEP is attached.
CC Lifetime Length of time to hold messages about this MEP in the CCM database
Age of Last CC Message Length of time the last CCM message about this MEP has been in the CCM database
Frame Loss Percentage of transmitted frames lost
CC Packet Statistics
(received/error) The number of CCM packets received successfully and those with errors
Port State Port states include:
Up – The port is functioning normally.
Blocked – The port has been blocked by the Spanning Tree Protocol.
No port state – Either no CCM has been received, or nor port status TLV was received
in the last CCM.
Interface State Interface states include:
No Status – Either no CCM has been received, or no interface status TLV was received
in the last CCM.
Up – The interface is ready to pass packets.
Down – The interface cannot pass packets.
Testing – The interface is in some test mode.
Unknown – The interface status cannot be determined for some reason.
Dormant – The interface is not in a state to pass packets but is in a pending state,
waiting for some external event.
Not Present – Some component of the interface is missing.
isLowerLayerDown – The interface is down due to state of the lower layer interfaces.
Crosscheck Status Shows if crosscheck function has been enabled.