Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 993)

Brocade 6910 Ethernet Access Switch Configuration Guide 943
53-1002581-01
Simple Network Management Protocol
42
• AES192 - Uses SNMPv3 with privacy with AES192 encryption.
• AES256 - Uses SNMPv3 with privacy with AES256 encryption.
• DES56 - Uses SNMPv3 with privacy with DES56 encryption.
• Privacy Password – A minimum of eight plain text characters is required.
Interface
To configure a remote SNMPv3 user:
1. Click Administration, SNMP.
2. Select Configure User from the Step list.
3. Select Add SNMPv3 Remote User from the Action list.
4. Enter a name and assign it to a group. Enter the IP address to identify the source of SNMPv3
inform messages sent from the local switch. If the security model is set to SNMPv3 and the
security level is authNoPriv or authPriv, then an authentication protocol and password must be
specified. If the security level is authPriv, a privacy password must also be specified.
5. Click Apply
FIGURE 260 Configuring Remote SNMPv3 Users
To show remote SNMPv3 users:
1. Click Administration, SNMP.
2. Select Configure User from the Step list.
3. Select Show SNMPv3 Remote User from the Action list.