Mvr for ipv6, Table 117 – Brocade Communications Systems Brocate Ethernet Access Switch 6910 User Manual
Page 541
Brocade 6910 Ethernet Access Switch Configuration Guide
491
53-1002581-01
MVR for IPv6
23
MVR for IPv6
This section describes commands used to configure Multicast VLAN Registration for IPv6 (MVR6). A
single network-wide VLAN can be used to transmit multicast traffic (such as television channels)
across a service provider’s network. Any multicast traffic entering an MVR VLAN is sent to all
subscribers. This can significantly reduce to processing overhead required to dynamically monitor
and establish the distribution tree for a normal multicast VLAN. Also note that MVR maintains the
user isolation and data security provided by VLAN segregation by passing only multicast traffic into
other VLANs to which the subscribers belong.
Specific Query Sent
The number of specific queries sent from this interface.
Number of Reports Sent
The number of reports sent from this interface.
Number of Leaves Sent
The number of leaves sent from this interface.
TABLE 116
show mvr statistics query - display description (Continued)
Field
Description
TABLE 117
Multicast VLAN Registration for IPv6 Commands
Command
Function
Mode
Binds the MVR group addresses specified in a profile to an MVR
domain
GC
Enables MVR for a specific domain
GC
Maps a range of MVR group addresses to a profile
GC
Enables MVR proxy switching, where the source port acts as a host,
and the receiver port acts as an MVR router with querier service
enabled
GC
Configures the expected packet loss, and thereby the number of times
to generate report and group-specific queries
GC
Configures the source IP address assigned to all control packets sent
upstream
GC
Specifies the VLAN through which MVR multicast data is received
GC
Enables immediate leave capability
IC
Configures an interface as an MVR receiver or source port
IC
Statically binds a multicast group to a port
IC
Shows information about MVR domain settings, including MVR
operational status, the multicast VLAN, the current number of group
addresses, and the upstream source IP address
PE
Shows the profiles bound the specified domain
PE
Shows MVR settings for interfaces attached to the MVR VLAN
PE