Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 466)

416 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
Configuring Voice VLANs
20
switchport voice vlan security
This command enables security filtering for VoIP traffic on a port. Use the no form to disable
filtering on a port.
Syntax
[no] switchport voice vlan security
Default Setting
Disabled
Command Mode
Interface Configuration
Command Usage
• Security filtering discards any non-VoIP packets received on the port that are tagged with the
voice VLAN ID. VoIP traffic is identified by source MAC addresses configured in the Telephony
OUI list, or through LLDP that discovers VoIP devices attached to the switch. Packets received
from non-VoIP sources are dropped.
• When enabled, be sure the MAC address ranges for VoIP devices are configured in the
Telephony OUI list (
voice vlan mac-address ).
Example
The following example enables security filtering on port 1.
Console(config)#interface ethernet 1/1
Console(config-if)#switchport voice vlan security
Console(config-if)#
show voice vlan
This command displays the Voice VLAN settings on the switch and the OUI Telephony list.
Syntax
show voice vlan {oui | status}
oui - Displays the OUI Telephony list.
status - Displays the global and port Voice VLAN settings.
Default Setting
None
Command Mode
Privileged Exec
Example
Console#show voice vlan status
Global Voice VLAN Status
Voice VLAN Status : Enabled
Voice VLAN ID : 1234