Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 252)

202 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
Network Access (MAC Address Authentication)
10
network-access guest-vlan
Use this command to assign all traffic on a port to a guest VLAN when 802.1x authentication is
rejected. Use the no form of this command to disable guest VLAN assignment.
Syntax
network-access guest-vlan vlan-id
no network-access guest-vlan
vlan-id - VLAN ID (Range: 1-4093)
Default Setting
Disabled
Command Mode
Interface Configuration
Command Usage
• The VLAN to be used as the guest VLAN must be defined and set as active (See the vlan
database command).
• When used with 802.1X authentication, the intrusion-action must be set for “guest-vlan” to be
effective (see the
dot1x intrusion-action command).
Example
Console(config)#interface ethernet 1/1
Console(config-if)#network-access guest-vlan 25
Console(config-if)#
network-access link-detection
Use this command to enable link detection for the selected port. Use the no form of this command
to restore the default.
Syntax
[no] network-access link-detection
Default Setting
Disabled
Command Mode
Interface Configuration
Example
Console(config)#interface ethernet 1/1
Console(config-if)#network-access link-detection
Console(config-if)#