Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 984)

934 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
Simple Network Management Protocol
42
Interface
To configure a remote SNMP engine ID:
1. Click Administration, SNMP.
2. Select Configure Engine from the Step list.
3. Select Add Remote Engine from the Action list.
4. Enter an ID of a least 9 hexadecimal characters, and the IP address of the remote host.
5. Click Apply
FIGURE 248 Configuring a Remote Engine ID for SNMP
To show the remote SNMP engine IDs:
1. Click Administration, SNMP.
2. Select Configure Engine from the Step list.
3. Select Show Remote Engine from the Action list.
FIGURE 249 Showing Remote Engine IDs for SNMP
Setting SNMPv3 Views
Use the Administration > SNMP (Configure View) page to configure SNMPv3 views which are used
to restrict user access to specified portions of the MIB tree. The predefined view “defaultview”
includes access to the entire MIB tree.
CLI References
• “snmp-server view” on page 118