Show logging, Table 20 – Brocade Communications Systems Brocate Ethernet Access Switch 6910 User Manual
Page 139
Brocade 6910 Ethernet Access Switch Configuration Guide
89
53-1002581-01
Event Logging
5
show logging
This command displays the configuration settings for logging messages to local switch memory, to
an SMTP event handler, or to a remote syslog server.
Syntax
show logging {flash | ram | sendmail | trap}
flash - Displays settings for storing event messages in flash memory (i.e., permanent
memory).
ram - Displays settings for storing event messages in temporary RAM (i.e., memory flushed
on power reset).
sendmail - Displays settings for the SMTP event handler (
).
trap - Displays settings for the trap function.
Default Setting
None
Command Mode
Privileged Exec
Example
The following example shows that system logging is enabled, the message level for flash memory is
“errors” (i.e., default level 3 - 0), and the message level for RAM is “debugging” (i.e., default level
7 - 0).
Console#show logging flash
Syslog logging: Enabled
History logging in FLASH: level errors
Console#show logging ram
Syslog logging: Enabled
History logging in RAM: level debugging
Console#
The following example displays settings for the trap function.
Console#show logging trap
Remote Log Status : Disabled
Remote Log Facility Type : Local use 7
Remote Log Level Type : Debugging messages
Remote Log Server IP Address : 0.0.0.0
Remote Log Server IP Address : 0.0.0.0
Remote Log Server IP Address : 0.0.0.0
Remote Log Server IP Address : 0.0.0.0
Remote Log Server IP Address : 0.0.0.0
TABLE 20
show logging flash/ram - display description
Field
Description
Syslog logging
Shows if system logging has been enabled via the
command.
History logging in FLASH
The message level(s) reported based on the
command.
History logging in RAM
The message level(s) reported based on the
command.