Garp timer – Brocade Communications Systems Brocate Ethernet Access Switch 6910 User Manual
Page 425
Brocade 6910 Ethernet Access Switch Configuration Guide
375
53-1002581-01
GVRP and Bridge Extension Commands
20
garp timer
This command sets the values for the join, leave and leaveall timers. Use the no form to restore the
timers’ default values.
Syntax
garp timer {join | leave | leaveall} timer-value
no garp timer {join | leave | leaveall}
{join | leave | leaveall} - Timer to set.
timer-value - Value of timer.
Ranges:
join: 20-1000 centiseconds
leave: 60-3000 centiseconds
leaveall: 500-18000 centiseconds
Default Setting
join: 20 centiseconds
leave: 60 centiseconds
leaveall: 1000 centiseconds
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
•
Group Address Registration Protocol is used by GVRP and GMRP to register or deregister client
attributes for client services within a bridged LAN. The default values for the GARP timers are
independent of the media access method or data rate. These values should not be changed
unless you are experiencing difficulties with GMRP or GVRP registration/deregistration.
•
Timer values are applied to GVRP for all the ports on all VLANs.
•
Timer values must meet the following restrictions:
•
leave >= (3 x join)
•
leaveall > leave
NOTE
Set GVRP timers on all Layer 2 devices connected in the same network to the same values.
Otherwise, GVRP may not operate successfully.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#garp timer join 100
Console(config-if)#
Related Commands