Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 274)

224 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
DHCP Snooping
10
Example
Console(config)#ip dhcp snooping database flash
Console(config)#
ip dhcp snooping database flash
This command writes all dynamically learned snooping entries to flash memory.
Command Mode
Privileged Exec
Command Usage
This command can be used to store the currently learned dynamic DHCP snooping entries to flash
memory. These entries will be restored to the snooping table when the switch is reset. However,
note that the lease time shown for a dynamic entry that has been restored from flash memory will
no longer be valid.
Example
Console(config)#ip dhcp snooping database flash
Console(config)#
show ip dhcp snooping
This command shows the DHCP snooping configuration settings.
Command Mode
Privileged Exec
Example
Console#show ip dhcp snooping
Global DHCP Snooping status: disable
DHCP Snooping Information Option Status: disable
DHCP Snooping Information Policy: replace
DHCP Snooping is configured on the following VLANs:
1
Verify Source Mac-Address: enable
Interface Trusted
---------- ----------
Eth 1/1 No
Eth 1/2 No
Eth 1/3 No
Eth 1/4 No
Eth 1/5 Yes
.
.
.
show ip dhcp snooping binding
This command shows the DHCP snooping binding table entries.
Command Mode
Privileged Exec