Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 748)

698 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
Trunk Configuration
33
4. Modify the required interface settings. (Refer to “Configuring by Port List” on page 675 for a
description of the parameters.)
5. Click Apply.
FIGURE 52 Configuring Connection Parameters for a Static Trunk
To display trunk connection parameters:
1. Click Interface, Trunk, Static.
2. Select Configure General from the Step list.
3. Select Show Information from the Action list.
FIGURE 53 Showing Information for Static Trunks
Configuring a Dynamic Trunk
Use the Interface > Trunk > Dynamic pages to set the administrative key for an aggregation group,
enable LACP on a port, configure protocol parameters for local and partner ports, or to set Ethernet
connection parameters.
FIGURE 54 Configuring Dynamic Trunks
active
links
}
}
dynamically
enabled
configured
members
backup
link