Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 1129)

Brocade 6910 Ethernet Access Switch Configuration Guide 1079
53-1002581-01
Filtering and Throttling IGMP Groups
46
FIGURE 369 Adding Multicast Groups to an IGMP Filtering Profile
To show the multicast groups configured for an IGMP filter profile:
1. Click Multicast, IGMP Snooping, Filter.
2. Select Configure Profile from the Step list.
3. Select Show Multicast Group Range from the Action list.
4. Select the profile for which to display this information.
FIGURE 370 Showing the Groups Assigned to an IGMP Filtering Profile
Configuring IGMP Filtering and Throttling for Interfaces
Use the Multicast > IGMP Snooping > Filter (Configure Interface) page to assign and IGMP filter
profile to interfaces on the switch, or to throttle multicast traffic by limiting the maximum number of
multicast groups an interface can join at the same time.
CLI References
• “IGMP Filtering and Throttling” on page 468
Command Usage
• IGMP throttling sets a maximum number of multicast groups that a port can join at the same
time. When the maximum number of groups is reached on a port, the switch can take one of
two actions; either “deny” or “replace.” If the action is set to deny, any new IGMP join reports
will be dropped. If the action is set to replace, the switch randomly removes an existing group
and replaces it with the new multicast group.