Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 377)

Brocade 6910 Ethernet Access Switch Configuration Guide 327
53-1002581-01
Chapter
17
Address Table Commands
These commands are used to configure the address table for filtering specified addresses,
displaying current entries, clearing the table, or setting the aging time.
mac-address-table aging-time
This command sets the aging time for entries in the address table. Use the no form to restore the
default aging time.
Syntax
mac-address-table aging-time seconds
no mac-address-table aging-time
seconds - Aging time. (Range: 10-844 seconds; 0 to disable aging)
Default Setting
300 seconds
Command Mode
Global Configuration
Command Usage
The aging time is used to age out dynamically learned forwarding information.
Example
Console(config)#mac-address-table aging-time 100
Console(config)#
TABLE 75 Address Table Commands
Command Function Mode
mac-address-table
aging-time Sets the aging time of the address table GC
mac-address-table static Maps a static address to a port in a VLAN GC
clear mac-address-table
dynamic Removes any learned entries from the forwarding
database PE
show mac-address-table Displays entries in the bridge-forwarding database PE
show mac-address-table
aging-time Shows the aging time for the address table PE
show mac-address-table
count Shows the number of MAC addresses used and the
number of available MAC addresses PE