Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 725)

Brocade 6910 Ethernet Access Switch Configuration Guide 675
53-1002581-01
Chapter
33
Interface Configuration
In this chapter
This chapter describes the following topics:
• Port Configuration – Configures connection settings, including auto-negotiation, or manual
setting of speed, duplex mode, and flow control.
• Local Port Mirroring – Sets the source and target ports for mirroring on the local switch.
• Remote Port Mirroring – Configures mirroring of traffic from remote switches for analysis at a
destination port on the local switch.
• Displaying Statistics – Shows Interface, Etherlike, and RMON port statistics in table or chart
form.
• Configuring History Sampling – Configures statistical sampling for the specified interfaces.
• Displaying Transceiver Data – Displays identifying information and functional parameters for
optical transceivers.
• Cable Test – Performs cable diagnostics on the specified port.
• Trunk Configuration – Configures static or dynamic trunks.
• Saving Power – Adjusts the power provided to ports based on the length of the cable used to
connect to other devices.
• Flow Sampling – Configures periodic sampling of traffic flows.
• Traffic Segmentation – Configures the uplinks and down links to a segmented group of ports.
• VLAN Trunking – Configures a tunnel across one or more intermediate switches which pass
traffic for VLAN groups to which they do not belong.
Port Configuration
This section describes how to configure port connections, mirror traffic from one port to another,
and run cable diagnostics.
Configuring by Port List
Use the Interface > Port > General (Configure by Port List) page to enable/disable an interface, set
auto-negotiation and the interface capabilities to advertise, or manually fix the speed, duplex
mode, and flow control.
CLI References
• “Interface Commands” on page 261