Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 405)

Brocade 6910 Ethernet Access Switch Configuration Guide 355
53-1002581-01
Spanning Tree Commands
18
Example
This example disables the spanning tree algorithm for port 5.
Console(config)#interface ethernet 1/5
Console(config-if)#spanning-tree spanning-disabled
Console(config-if)#
spanning-tree loopback-detection release
This command manually releases a port placed in discarding state by loopback-detection.
Syntax
spanning-tree loopback-detection release interface
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-12)
port-channel channel-id (Range: 1-12)
Command Mode
Privileged Exec
Command Usage
Use this command to release an interface from discarding state if loopback detection release
mode is set to “manual” by the
spanning-tree loopback-detection release-mode command and
BPDU loopback occurs.
Example
Console#spanning-tree loopback-detection release ethernet 1/1
Console#
spanning-tree protocol-migration
This command re-checks the appropriate BPDU format to send on the selected interface.
Syntax
spanning-tree protocol-migration interface
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-12)
port-channel channel-id (Range: 1-12)
Command Mode
Privileged Exec