Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 757)

Brocade 6910 Ethernet Access Switch Configuration Guide 707
53-1002581-01
Trunk Configuration
33
Interface
To display LACP settings and status for the remote side:
1. Click Interface, Trunk, Dynamic.
2. Select Configure Aggregation Port from the Step list.
3. Select Show Information from the Action list.
4. Click Internal.
5. Select a group member from the Port list.
FIGURE 63 Displaying LACP Port Remote Information
Configuring Load Balancing
Use the Interface > Trunk > Load Balance page to set the load-distribution method used among
ports in aggregated links.
CLI References
• “port channel load-balance” on page 290
Command Usage
• This command applies to all static and dynamic trunks on the switch.
• To ensure that the switch traffic load is distributed evenly across all links in a trunk, select the
source and destination addresses used in the load-balance calculation to provide the best
result for trunk connections:
• Destination IP Address: All traffic with the same destination IP address is output on the
same link in a trunk. This mode works best for switch-to-router trunk links where traffic
through the switch is destined for many different hosts. Do not use this mode for
switch-to-server trunk links where the destination IP address is the same for all traffic.