Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 620)

570 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
OAM Commands
26
show efm oam event-log interface
This command displays the OAM event log for the specified port(s) or for all ports that have logs.
show efm oam event-log interface [interface-list]
interface-list - unit/port
unit - Unit identifier. (Range: 1)
port - Port number or list of ports. To enter a list, separate nonconsecutive port
identifiers with a comma and no spaces; use a hyphen to designate a range of ports.
(Range: 1-12)
Command Mode
Normal Exec, Privileged Exec
Command Usage
• When a link event occurs, no matter whether the location is local or remote, this information is
entered in the OAM event log.
• When the log system becomes full, older events are automatically deleted to make room for
new entries.
Example
Console#show efm oam event-log interface 1/1
OAM event log of Eth 1/1:
00:24:07 2001/01/01
"Unit 1, Port 1: Dying Gasp at Remote"
Console#
show efm oam remote-loopback interface
This command displays the results of an OAM remote loopback test.
Syntax
show efm oam remote-loopback interface [interface-list]
interface-list - unit/port
unit - Unit identifier. (Range: 1)
port - Port number or list of ports. To enter a list, separate nonconsecutive port
identifiers with a comma and no spaces; use a hyphen to designate a range of ports.
(Range: 1-12)
Command Mode
Normal Exec, Privileged Exec
Example
Console#show efm oam remote-loopback interface 1/1
Port OAM loopback Tx OAM loopback Rx Loss Rate
---- --------------- --------------- ---------
1/1 10000 9999 0.01 %
Console#