Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 312)

262 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
Interface Commands
12
interface
This command configures an interface type and enters interface configuration mode. Use the no
form with a trunk to remove an inactive interface.
Syntax
[no] interface interface
interface
craft - Management port on the front panel.
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-12)
port-channel channel-id (Range: 1-12)
vlan vlan-id (Range: 1-4093)
Default Setting
None
Command Mode
Global Configuration
Command Usage
• The craft interface is provided as an out-of-band management connection which is isolated
from all other ports on the switch. This interface must first be configured with an IPv4 or IPv6
address before a connection can be made through Telnet, SSH, or HTTP.
show interfaces switchport Displays the administrative and operational status of an interface NE, PE
show interfaces transceiver Displays the temperature, voltage, bias current, transmit power, and
receive power information on connector type and vendor-related
parameters PE
Cable Diagnostics
test cable-diagnostics Performs cable diagnostics on the specified port PE
show cable-diagnostics Shows the results of a cable diagnostics test PE
Power Savings
power-save Enables power savings mode on the specified port IC
show power-save Shows the configuration settings for power savings PE
* Enabling hardware-level storm control with this command on a port will disable software-level automatic storm control on
the same port if configured by the auto-traffic-control command ( page 317 ).
TABLE 63 Interface Commands (Continued)
Command Function Mode