Ipv6 interface, Table 144 – Brocade Communications Systems Brocate Ethernet Access Switch 6910 User Manual
Page 649
Brocade 6910 Ethernet Access Switch Configuration Guide
599
53-1002581-01
IPv6 Interface
29
Example
This example displays all entries in the ARP cache.
Console#show arp
ARP Cache Timeout: 1200 (seconds)
IP Address MAC Address Type Interface
--------------- ----------------- --------- -----------
10.1.0.0 FF-FF-FF-FF-FF-FF other VLAN1
10.1.0.254 00-00-AB-CD-00-00 other VLAN1
10.1.0.255 FF-FF-FF-FF-FF-FF other VLAN1
145.30.20.23 09-50-40-30-20-10 dynamic VLAN3
Total entry : 5
Console#
IPv6 Interface
This switch supports the following IPv6 interface commands.
TABLE 144
IPv6 Configuration Commands
Command
Function
Mode
Interface Address Configuration and Utilities
Sets an IPv6 default gateway for traffic
GC
Configures an IPv6 global unicast address, and enables IPv6 on an
interface
IC
Enables automatic configuration of IPv6 addresses on an interface
and enables IPv6 on the interface
IC
Configures an IPv6 global unicast address for an interface using an
EUI-64 interface ID in the low order 64 bits, and enables IPv6 on the
interface
IC
Configures an IPv6 link-local address for an interface and enables IPv6
on the interface
IC
Enables IPv6 on an interface that has not been configured with an
explicit IPv6 address
IC
Sets the size of the maximum transmission unit (MTU) for IPv6 packets
sent on an interface
IC
Displays the current IPv6 default gateway
NE, PE
Displays the usability and configured settings for IPv6 interfaces
NE, PE
Displays maximum transmission unit (MTU) information for IPv6
interfaces
NE, PE
Displays statistics about IPv6 traffic
NE, PE
Resets IPv6 traffic counters
PE
Sends IPv6 ICMP echo request packets to another node on the
network
PE
Shows the route packets take to the specified host
PE