Mvr vlan – Brocade Communications Systems Brocate Ethernet Access Switch 6910 User Manual
Page 531
Brocade 6910 Ethernet Access Switch Configuration Guide
481
53-1002581-01
MVR for IPv4
23
Example
Console(config)#mvr domain 1 upstream-source-ip 192.168.0.3
Console(config)#
mvr vlan
This command specifies the VLAN through which MVR multicast data is received. Use the no form
of this command to restore the default MVR VLAN.
Syntax
mvr domain domain-id vlan vlan-id
no mvr domain domain-id vlan
domain-id - An independent multicast domain. (Range: 1-5)
vlan-id - Specifies the VLAN through which MVR multicast data is received. This is also the
VLAN to which all source ports must be assigned. (Range: 1-4093)
Default Setting
VLAN 1
Command Mode
Global Configuration
Command Usage
•
This command specifies the VLAN through which MVR multicast data is received. This is the
VLAN to which all source ports must be assigned.
•
The VLAN specified by this command must be an existing VLAN configured with the
command.
•
MVR source ports can be configured as members of the MVR VLAN using the
command, but MVR receiver ports should
not be statically configured as members of this VLAN.
Example
The following example sets the MVR VLAN to VLAN 2:
Console(config)#mvr
Console(config)#mvr domain 1 vlan 2
Console(config)#