Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 342)

292 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
Link Aggregation Commands
13
Example
The following example creates trunk 1 and then adds port 10:
Console(config)#interface port-channel 1
Console(config-if)#exit
Console(config)#interface ethernet 1/10
Console(config-if)#channel-group 1
Console(config-if)#
lacp
This command enables 802.3ad Link Aggregation Control Protocol (LACP) for the current interface.
Use the no form to disable it.
Syntax
[no] lacp
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet)
Command Usage
• The ports on both ends of an LACP trunk must be configured for full duplex, either by forced
mode or auto-negotiation.
• A trunk formed with another switch using LACP will automatically be assigned the next
available port-channel ID.
• If the target switch has also enabled LACP on the connected ports, the trunk will be activated
automatically.
• If more than eight ports attached to the same target switch have LACP enabled, the additional
ports will be placed in standby mode, and will only be enabled if one of the active links fails.
Example
The following shows LACP enabled on ports 1-3. Because LACP has also been enabled on the ports
at the other end of the links, the
show interfaces status port-channel 1 command shows that
Trunk1 has been established.
Console(config)#interface ethernet 1/1
Console(config-if)#lacp
Console(config-if)#interface ethernet 1/2
Console(config-if)#lacp
Console(config-if)#interface ethernet 1/3
Console(config-if)#lacp
Console(config-if)#end
Console#show interfaces status port-channel 1
Information of Trunk 1
Basic Information:
Port Type : 1000BASE-T
MAC Address : 12-34-12-34-12-3F
Configuration:
Name :