Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 633)

Brocade 6910 Ethernet Access Switch Configuration Guide 583
53-1002581-01
DHCP Client
28
Console#ip dhcp restart client
Console#show ip interface
VLAN 1 is Administrative Up - Link Up
Address is 12-34-12-34-12-34
Index: 1001, MTU: 1500
Address Mode is DHCP
IP Address: 192.168.0.9 Mask: 255.255.255.0
Proxy ARP is disabled
Console#
Related Commands
ip address (590)
ipv6 dhcp client rapid-commit vlan
This command specifies the Rapid Commit option for DHCPv6 message exchange for all DHCPv6
client requests submitted from the specified interface. Use the no form to disable this option.
Syntax
[no] ipv6 dhcp client rapid-commit vlan vlan-id
vlan-id - VLAN ID, specified as a single number, a range of consecutive numbers separated
by a hyphen, or multiple numbers separated by commas. (Range: 1-4093; Maximum
command length: 300 characters)
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
• DHCPv6 clients can obtain configuration parameters from a server through a normal
four-message exchange (solicit, advertise, request, reply), or through a rapid two-message
exchange (solicit, reply). The rapid-commit option must be enabled on both client and server
for the two-message exchange to be used.
• This command allows two-message exchange method for prefix delegation. When enabled,
DCHPv6 client requests submitted from the specified interface will include the rapid commit
option in all solicit messages.
Example
Console(config)#ipv6 dhcp client rapid-commit vlan 2
Console(config)#