Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 756)

706 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
Trunk Configuration
33
FIGURE 62 Displaying LACP Port Internal Information
Displaying LACP Settings and Status for the Remote Side
Use the Interface > Trunk > Dynamic (Configure Aggregation Port - Show Information - Neighbors)
page to display the configuration settings and operational state for the remote side of a link
aggregation.
CLI References
• “show lacp” on page 297
Parameters
These parameters are displayed:
TABLE 156 LACP Remote Device Configuration Information
Parameter Description
Partner Admin System ID LAG partner’s system ID assigned by the user.
Partner Oper System ID LAG partner’s system ID assigned by the LACP protocol.
Partner Admin
Port Number Current administrative value of the port number for the protocol Partner.
Partner Oper
Port Number Operational port number assigned to this aggregation port by the port’s protocol
partner.
Port Admin Priority Current administrative value of the port priority for the protocol partner.
Port Oper Priority Priority value assigned to this aggregation port by the partner.
Admin Key Current administrative value of the Key for the protocol partner.
Oper Key Current operational value of the Key for the protocol partner.
Admin State Administrative values of the partner’s state parameters. (See preceding table.)
Oper State Operational values of the partner’s state parameters. (See preceding table.)