Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) - Manual (Page 753)

Unified IP MIB Reference 725
53-1002549-02
General traps for the Brocade NetIron devices
snTrapUpgradeSingleCmd
Start
brcdIp.0.1216 snAgGblTrapMessage Informational The SNMP trap is generated when a
single-command package upgrade is
started. This happens after a successful
download and validation of the manifest file
and before the first image download takes
place.
snTrapUpgradeSingleCmd
Done
brcdIp.0.1217 snAgGblTrapMessage Informational The SNMP trap is generated when a
single-command package upgrade is
completed or partially completed. Refer to
brcdSwPackageLoadResultTable for the
results of the upgrade.
snTrapAutoUpgradeStart
brcdIp.0.1218 snAgentBrdIndex Informational The SNMP trap is generated when an
auto-upgrade on a line card is started.
snTrapAutoUpgradeDone
brcdIp.0.1219 snAgentBrdIndex,
snAgGblTrapMessage Informational The SNMP trap is generated when an
auto-upgrade of the interface module is
completed.
snTrapTcamParityError
brcdIp.0.1220 snAgentBrdIndex,
snAgGblTrapMessage Alerts The SNMP trap is generated when the TCAM
parity errors are detected on LP.
snTrapLPResetOnTcamErro
r
brcdIp.0.1221 snAgentBrdIndex,
snAgGblTrapMessage Critical The SNMP trap is generated when the LP
reset happens due to TCAM parity errors
crossing the threshold or TCAM integrity
check failure.
Trap name and number Varbinds Severity Description and trap message