Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) - Manual (Page 682)

654 Unified IP MIB Reference
53-1002549-02
Web cache traffic statistics table
snL4WebCacheCurrConne
ctions
brcdIp.1.1.4.16.1.1.3
Syntax: Integer Read-only Shows the number of the active connections between the clients
and the Web cache server.
snL4WebCacheTotalConne
ctions
brcdIp.1.1.4.16.1.1.4
Syntax: Integer Read-only Shows the total number of connections between clients and the
Web cache server.
snL4WebCacheTxPkts
brcdIp.1.1.4.16.1.1.5
Syntax: Counter Read-only Shows the number of packets sent from the client or the Web
server to the Web cache server.
snL4WebCacheRxPkts
brcdIp.1.1.4.16.1.1.6
Syntax: Counter Read-only Shows the number of packets sent from the Web cache server to
the client or Web server.
snL4WebCacheTxOctets
brcdIp.1.1.4.16.1.1.7
Syntax: Counter Read-only Shows the number of octets sent from the client or Web server to
the Web cache server.
snL4WebCacheRxOctets
brcdIp.1.1.4.16.1.1.8
Syntax: Counter Read-only Shows the number of octets sent from the Web cache server to
the client or Web server.
snL4WebCachePortState
brcdIp.1.1.4.16.1.1.9
Syntax: WebCacheState Read-only Shows the operational state of the server port:
•
disabled(0) – This state has been deprecated.
•
enabled(1) – The server is ready. There is no physical link to
the Web cache server. The Web cache server is configured
on the ServerIron, but is not physically connected to the
ServerIron.
•
failed(2) – The server failed. The Web cache server has
failed to respond to repeated Layer 3 health checks (IP
pings. Typically, a real server changes from the suspect(4)
state to the failed(2) state.
•
testing(3) – The Web cache server is in testing mode. It is
still reachable at Layer 3, but at least one of its application
ports has failed to respond to its health checks. If the
application port is not a TCP or UDP port known to the
ServerIron, or if the Layer 7 health check for the port is
disabled, only the Layer 4 health check is used. If the
service is a TCP or UDP port known to the ServerIron and the
Layer 7 health check is enabled, then the application must
pass both health checks to avoid entering the testing(3)
state.
The ServerIron continues to try to the reach the application
indefinitely. Thus, if the server continues to be reachable at
Layer 3, the state will remain in the testing(3) state as long
as the ServerIron cannot reach the application that is failing
its health check..
Name, OID, and syntax Access Description