Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) - Manual (Page 547)

Unified IP MIB Reference 519
53-1002549-02
OSPF neighbor table
OSPF neighbor table
The OSPF neighbor table describes non-virtual neighbors in the locality of the router.
References:
• RFC 1583 “OSPF Version 2”, section 10 The Neighbor Data Structure
• RFC 1583 “OSPF Version 2”, section 12.1.2 Options
NOTE
The following objects in this section are not supported on the Brocade MLXe router, Brocade NetIron
XMR, Brocade NetIron MLX, Brocade NetIron CES, and Brocade NetIron CER series devices.
snOspfRedisRipMetricValue
brcdIp.1.2.4.6.1.1.9
Syntax: Integer Read-write Specifies the cost of using RIP on this interface.
Valid values: 1 – 15 hops
snOspfRedisRowStatus
brcdIp.1.2.4.6.1.1.10
Syntax: Integer Read-write Controls the management of the table rows. The following values
can be written:
•
delete(3) – Deletes the row.
•
create(4) – Creates a new row.
•
modify(5) – Modifies an existing row.
If the row exists, then a SET with a value of create(4) returns a "bad
value" error. Deleted rows are removed from the table immediately.
The following values can be returned on reads:
•
noSuch(0) – No such row.
•
invalid(1) – Row is inoperative.
•
valid(2) – Row exists and is valid.
Name, OID, and syntax Access Description
Name, OID, and syntax Access Description
snOspfNbrTable
brcdIp.1.2.4.7.1 None A table of non-virtual neighbor information.
snOspfNbrEntryIndex
brcdIp.1.2.4.7.1.1.1
Syntax: Integer32 Read-only The table entry index of this neighbor.
snOspfNbrPort
brcdIp.1.2.4.7.1.1.2
Syntax: Integer32 Read-only Shows the physical port ID of this neighbor.
snOspfNbrIpAddr
brcdIp.1.2.4.7.1.1.3
Syntax: IpAddress Read-only Shows the IP address of this neighbor.
snOspfNbrIndex
brcdIp.1.2.4.7.1.1.4
Syntax: Integer32 Read-only Contains an index of each neighbor’s port and IP address.
snOspfNbrRtrId
brcdIp.1.2.4.7.1.1.5
Syntax: RouterID Read-only Specifies the IP address of the neighboring router in the autonomous
system. The value of this object is a 32-bit integer.
Default: ’00000000’h, which is equal to 0.0.0.0