Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) - Manual (Page 235)

Unified IP MIB Reference 207
53-1002549-02
Chapter
9
Interface ID Registration Group
In this chapter
• Interface ID to ifIndex lookup table . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 207
• ifIndex to interface ID lookup table . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 208
• Interface ID2 to ifIndex lookup table . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 209
• ifIndex to interface ID2 lookup table . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 210
• ifIndex to optical parameters table . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 211
• Optical lane monitoring table . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 212
• Interface media information table . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 213
• Loopback interface configuration table. . . . . . . . . . . . . . . . . . . . . . . . . . . . 213
The new MP card MR2 supports all the table objects in snInterfaceLookupTable,
snIfIndexLookupTable, snInterfaceLookup2Table, and snIfIndexLookup2Table. The MP-MR2 is
supported only on the Brocade NetIron MLX, Brocade MLXe, and Brocade NetIron XMR devices.
Interface ID to ifIndex lookup table
Given an interface ID, the interface ID to ifIndex lookup table returns the ifIndex value. The table is
useful for mapping a known interface to the corresponding ifIndex value. The contents of the
interface ID to ifIndex lookup table can only be accessed using GET operations. Unlike other SNMP
tables, this table does not support GET-NEXT operations. If you try to walk the table using
GET-NEXT, no rows will be returned.
Name, OID, and syntax Access Description
snInterfaceLookupTable
brcdIp.1.1.3.3.3 None The Interface ID to ifIndex lookup table.
snInterfaceLookupInterfaceId
brcdIp.1.1.3.3.3.1.1
Syntax: InterfaceId Read-only Shows the interface ID, which consists of the following:
Octet 0 – Port type, which can be one of the following:
•
1 – Ethernet
•
2 – POS
•
3 – ATM
•
4 – Virtual
•
5 – Loopback
•
6 – GRE Tunnel
These values applies to Brocade NetIron XMR, Brocade
NetIron MLX, and to Brocade MLXe router devices.
•
7 – ATM Subif
•
8 – MPLS Tunnel