Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) - Manual (Page 512)

484 Unified IP MIB Reference
53-1002549-02
BGP4 neighbor general configuration table
BGP4 neighbor general configuration table
BGP4 does not contain a peer discovery process. You must indicate the neighbor’s IP address for
each of the router’s BGP4 neighbors (peers), as well as the AS each neighbor is in. Neighbors that
are in different autonomous systems communicate using EBGP. Neighbors within the same AS
communicate using IBGP.
NOTE
The following table is not supported on the Brocade MLXe router, Brocade NetIron MLX, Brocade
NetIron XMR, Brocade NetIron CES, and Brocade NetIron CER series devices.
Name, OID, and syntax Access Description
snBgp4NeighGenCfgTable
brcdIp.1.2.11.6.1 None The BGP4 neighborhood general configuration table.
snBgp4NeighGenCfgNeighIp
brcdIp.1.2.11.6.1.1.1
Syntax: IpAddress Read-only Shows the IP address for a neighbor entry.
snBgp4NeighGenCfgAdvertlevel
brcdIp.1.2.11.6.1.1.2
Syntax: Integer Read-write Specifies the minimum delay (in seconds) between
messages to the specified neighbor.
Valid values: 0 – 600
Defaults:
•
30 for EBGP neighbors (neighbors in other
autonomous systems )
•
5 for IBGP neighbors (neighbors in the same AS).
snBgp4NeighGenCfgDefOriginate
brcdIp.1.2.11.6.1.1.3
Syntax: Integer Read-write Indicates if the default originate for this neighbor is enabled:
•
disabled(0)
•
enabled(1)
If enabled, the device sends the default route 0.0.0.0 to the
neighbor.
snBgp4NeighGenCfgEbgpMultihop
brcdIp.1.2.11.6.1.1.4
Syntax: Integer Read-write Indicates if the EBGP multihop for this neighbor is enabled.
•
disabled(0)
•
enabled(1)
If enabled, the neighbor is more than one hop away and that
the session type with the neighbor is thus EBGP multihop.
Default: disabled(0)
snBgp4NeighGenCfgMaxPrefix
brcdIp.1.2.11.6.1.1.5
Syntax: Integer32 Read-write Specifies the maximum number of IP network prefixes
(routes) that can be learned from the specified neighbor or
peer group. You can specify a value from 0 through
4294967295.
Default: 0 (unlimited)
The minimum value of the maximum prefix is defined by the
“snBgp4GenNeighPrefixMinValue” object. The maximum
value of the maximum prefix is defined by the
“snBgp4GenOperRoutes” object.
snBgp4NeighGenCfgNextHopSelf
brcdIp.1.2.11.6.1.1.6
Syntax: Integer Read-write Indicates if the option that allows the router to list itself as
the next hop in the updates sent to the specified neighbor
is enabled:
•
disabled(0)
•
enabled(1)
Default: disabled(0)