Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) - Manual (Page 535)

Unified IP MIB Reference 507
53-1002549-02
OSPF area table
OSPF area table
The OSPF area data structure contains information that describes the various OSPF areas. The
interfaces and virtual links are configured as parts of these areas. Area 0.0.0.0, by definition, is the
Backbone Area.
NOTE
The following objects are not supported on the Brocade NetIron MLX, Brocade MLXe router, Brocade
NetIron XMR, Brocade NetIron CES, and Brocade NetIron CER series devices.
snOspfRfc1583Compatibi
lity
brcdIp.1.2.4.1.13
Syntax: Integer Read-write Specifies if the OSPF route is compatible with RFC 1583 or RFC 2178:
•
disabled(0) – Compatible with RFC 2178.
•
enabled(1) – Compatible with RFC 1583.
snOspfRouterIdFormat
brcdIp.1.2.4.1.14
Syntax: Integer Read-write Specifies the format of how the router ID will be entered in the
“snOspfRouterId” object:
•
integer(0) – Integer
•
ipAddress(1) – IP address
snOspfDistance
brcdIp.1.2.4.1.15
Syntax: Integer Read-write Determines the OSPF administrative distance area. The value is zero is
the distance is not set.
Valid values: 1 – 255
Default: 110
snOspfDistanceIntra
brcdIp.1.2.4.1.16
Syntax: Integer Read-write Determines the OSPF administrative distance for intra-area routes.
Valid values: 1 – 255
Default: 110
snOspfDistanceInter
brcdIp.1.2.4.1.17
Syntax: Integer Read-write Determines the OSPF administrative distance for inter-area routes.
Valid values: 1 – 255
Default: 110
snOspfDistanceExternal
brcdIp.1.2.4.1.18
Syntax: Integer Read-write Determines the OSPF administrative distance for external routes.
Valid values: 1 – 255
Default: 110
Name, OID, and syntax Access Description
Name, OID, and syntax Access Description
snOspfAreaTable
brcdIp.1.2.4.2.1 None The OSPF area table.
snOspfAreaId
brcdIp.1.2.4.2.1.1.1
Syntax: AreaID Read-only Specifies the address of the area. This address identifies the router,
independent of its IP address. Area ID 0.0.0.0 is used for the OSPF
backbone. The format used for this ID is specified by the
“snOspfAreaIdFormat” object.