Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) - Manual (Page 281)

Unified IP MIB Reference 253
53-1002549-02
Chapter
16
POS MIB Definition
In this chapter
• Packet port information table. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 253
• POS MIB information table . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 257
• POS PPP group. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 259
• POS cHDLC group . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 260
Packet port information table
Packet over SONET (POS) is the serial transmission of data over SONET frames through the use of
the Point-to-Point Protocol (PPP). The POS modules allow direct connection to interfaces within
SONET. POS is a transport technology that encapsulates packet data, such as an IP datagram,
directly into SONET.
The POS modules are available on NetIron Internet Backbone routers and BigIron Layer 3 Switches
with redundant management modules.
The following table presents information about POS ports.
NOTE
The following table is not supported on the Brocade NetIron MLX, Brocade MLXe, Brocade NetIron
XMR, Brocade NetIron CES, and Brocade NetIron CER series devices.
Name, OID, and syntax Access Description
snPOSInfoTable
brcdIp.1.2.14.1.1 None POS port information table.
snPOSInfoPortNum
brcdIp.1.2.14.1.1.1.1
Syntax: Integer Read-only The chassis slot and port number:
•
Bit 0 to bit 7 – Port number
•
Bit 8 to bit 11 – Slot number (for chassis devices only)
snPOSIfIndex
brcdIp.1.2.14.1.1.1.2
Syntax: Integer Read-only Identifies the instance of the ifIndex object as defined in RFC 1213
and RFC 1573.
snPOSDescr
brcdIp.1.2.14.1.1.1.3
Syntax: DisplayString Read-only Description of the chassis slot and port.
snPOSName
brcdIp.1.2.14.1.1.1.4
Syntax: DisplayString Read-write Name of the port.
Valid values: Up to 255 characters