Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) - Manual (Page 326)

298 Unified IP MIB Reference
53-1002549-02
Port VLAN configuration table
Port VLAN configuration table
snVLanByPortMemberPortId
brcdIp.1.1.3.2.6.1.2
Syntax: Integer Read-only The ifIndex that is a member of the port VLAN.
snVLanByPortMemberRowStat
us
brcdIp.1.1.3.2.6.1.3
Syntax: Integer Read-write Controls the management of the table rows. The following values
can be written:
•
delete(3) – Delete the row.
•
create(4) – Create a new row.
If the row exists, then a SET with a value of create(4) returns a bad
value error. Deleted rows are removed from the table immediately.
The following values can be returned on reads:
•
noSuch(0) – No such row.
•
other(1) – Some other case.
•
valid(2) – Row exists and is valid.
snVLanByPortMemberTagMod
e
brcdIp.1.1.3.2.6.1.4
Syntax: Integer Read-write For a tagged or dual-mode port, there can be multiple VLANs per
port. For an untagged port, there is only one VLAN ID per port.
The values are:
•
tagged(1)
•
untagged(2)
Name, OID, and syntax Access Description
Name, OID, and syntax Access Description
snVLanByPortCfgTable
brcdIp.1.1.3.2.7 None The Port VLAN (Layer 2 VLAN) configuration table.
snVLanByPortCfgEntry
brcdIp.1.1.3.2.7.1 None An entry of the port VLAN configuration table.
snVLanByPortCfgVLanId
brcdIp.1.1.3.2.7.1.1
Syntax: Integer Read-write The VLAN ID index to this table. Each VLAN identifier can be a member
of multiple ports.
Valid values: 1 – 4095
snVLanByPortCfgQos
brcdIp.1.1.3.2.7.1.2
Syntax: PortQosTC Read-write Shows the Quality of Service (QoS) settings for the devices.
For Stackable devices, the values can be one of the following:
•
low(0) – Low priority
•
high(1) – High priority
For Chassis devices, the value can be one of the following:
•
level0(0)
•
level1(1)
•
level2(2)
•
level3(3)
•
level4(4)
•
level5(5)
•
level6(6)
•
level7(7)
•
invalid(127) - This value is used by CES or CER products to signify
that no Quality of Service was specified for this VLAN.