Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) - Manual (Page 325)

Unified IP MIB Reference 297
53-1002549-02
VLAN by port membership table
VLAN by port membership table
The following table is the Port VLAN (Layer 2 VLAN) port membership table.
snVLanByPortBaseBridgeAd
dress
brcdIp.1.1.3.2.1.1.24
Syntax: BridgeId Read-only Indicates the value of the dot1dBaseBridgeAddress, which is the
MAC address used by this bridge when it must be referred to in a
unique fashion.
It is recommended that this is the smallest MAC address of all ports
that belong to this bridge; however, it must be unique. When
concatenated with dot1dStpPriority, a unique Bridge Identifier is
formed, which is used in the STP.
snVLanByPortVLanName
brcdIp.1.1.3.2.1.1.25
Syntax: DisplayString Read-write Indicates the name of the community string that is allowed to
access the VLAN.
Valid values: Up to 32 characters
snVLanByPortRouterIntf
brcdIp.1.1.3.2.1.1.26
Syntax: Integer32
NOTE: This object was
deprecated on
FastIron devices. It
is not supported on
the Brocade NetIron
MLX, Brocade MLXe,
Brocade NetIron
XMR, Brocade
NetIron CES, or
Brocade NetIron
CER series devices.
Use
snVLanByPortCfgRo
uterIntf instead.
Read-write This object is optional and applies only to routers.
It shows the ID of the virtual interface of a router to the VLAN.
If an SNMP-Get value is zero, then this object was not configured.
Valid values: 1 – 60
snVLanByPortChassisPortM
ask
brcdIp.1.1.3.2.1.1.27
Syntax: OCTET STRING Read-write The object is replaced by “snVLanByPortPortList” .
It shows the VLAN switch port membership.
This object has 32 octets.
snVLanByPortPortList
brcdIp.1.1.3.2.1.1.28
Syntax: OCTET STRING Read-write Applies to all devices.
Name, OID, and syntax Access Description
Name, OID, and syntax Access Description
snVLanByPortMemberTable
brcdIp.1.1.3.2.6 None This table is used to create or delete a port VLAN (Layer 2 VLAN)
entry.
snVLanByPortMemberEntry
brcdIp.1.1.3.2.6.1 None An entry in the Port VLAN port membership table.
snVLanByPortMemberVLanId
brcdIp.1.1.3.2.6.1.1
Syntax: Integer Read-only The VLAN identifier (VLAN ID).
Valid values: 1 – 4095 VLAN IDs