Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) - Manual (Page 525)

Unified IP MIB Reference 497
53-1002549-02
BGP4 neighbor operational status table
BGP4 neighbor operational status table
The BGP4 neighbor operational status table shows the state of a neighbor and statistics about the
messages sent and received.
NOTE
The following table is not supported on the Brocade MLXe router, Brocade NetIron MLX, Brocade
NetIron XMR, Brocade NetIron CES, and Brocade NetIron CER series devices.
snBgp4RouteMapSetDampenSupp
ress
brcdIp.1.2.11.14.1.1.19
Syntax: Integer Read-write The BGP4 route map dampening suppress.
snBgp4RouteMapSetDampenMaxS
uppress
brcdIp.1.2.11.14.1.1.20
Syntax: Integer Read-write The BGP4 route map dampening maximum suppress time.
Name, OID, and syntax Access Description
Name, OID, and syntax Access Description
snBgp4NeighOperStatusTable
brcdIp.1.2.11.15.1 None The BGP4 neighbor operational status table.
snBgp4NeighOperStatusIndex
brcdIp.1.2.11.15.1.1.1
Syntax: Integer32 Read-only The index for the entry. Each entry represents a neighbor.
snBgp4NeighOperStatusIp
brcdIp.1.2.11.15.1.1.2
Syntax: IpAddress Read-only Shows the IP address of the neighbor.
snBgp4NeighOperStatusRemoteAs
brcdIp.1.2.11.15.1.1.3
Syntax: Integer32 Read-only Shows the AS that the neighbor is in.
snBgp4NeighOperStatusBgpType
brcdIp.1.2.11.15.1.1.4
Syntax: Integer Read-only Shows the type of BGP used by this entry:
•
ebgp(0) – The neighbor is in another AS.
•
ibgp(1) – The neighbor is in the same AS.