Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) - Manual (Page 59)

Unified IP MIB Reference 31
53-1002549-02
RFC 2934: Protocol Independent Multicast MIB for IPv4
pimNeighborTable (PIM neighbor table)
Use the show ip pim neighbor command to display information about the PIM neighbor table.
The SET request is not supported for this table.
)
pimIpMRouteTable (PIM IP multicast route table)
NOTE
The PIM IP multicast route table MIBs are not supported on the Brocade NetIron XMR, Brocade
NetIron MLX, Brocade MLXe, Brocade NetIron CES, and Brocade NetIron CER series devices.
The show ip pim mcache command displays information about the PIM IP multicast route table.
Object Object identifier Supported?
pimInterfaceIfIndex 1.3.6.1.3.61.1.1.2.1.1 Yes
pimInterfaceAddress 1.3.6.1.3.61.1.1.2.1.2 Yes, but read-only.
pimInterfaceNetMask 1.3.6.1.3.61.1.1.2.1.3 Yes, but read-only.
pimInterfaceMode 1.3.6.1.3.61.1.1.2.1.4 Yes, but read-only.
NOTE: On Brocade NetIron MLX
,
Brocade MLXe , Brocade
NetIron XMR , Brocade
NetIron CES , and Brocade
NetIron CER series devices,
only dense and sparse
modes are supported.
pimInterfaceDR 1.3.6.1.3.61.1.1.2.1.5 Yes, but read-only.
pimInterfaceHelloInterval 1.3.6.1.3.61.1.1.2.1.6 Yes, but read-only.
pimInterfaceStatus 1.3.6.1.3.61.1.1.2.1.7 Yes, but read-only. Returns “active”.
pimInterfaceJoinPruneInter
val 1.3.6.1.3.61.1.1.2.1.8 Yes, but read-only.
pimInterfaceCBSRPreferen
ce 1.3.6.1.3.61.1.1.2.1.9 Yes, but read-only.
NOTE: On Brocade NetIron MLX
,
Brocade MLXe , Brocade
NetIron XMR , Brocade
NetIron CES , and Brocade
NetIron CER series devices,
the constant value for this
object is 0.
Object Object identifier Supported?
pimNeighborAddress 1.3.6.1.3.61.1.1.3.1.1 Yes
pimNeighborIfIndex 1.3.6.1.3.61.1.1.3.1.2 Yes, but read-only.
pimNeighborUpTime 1.3.6.1.3.61.1.1.3.1.3 Yes, but read-only.
pimNeighborExpiryTime 1.3.6.1.3.61.1.1.3.1.4 Yes, but read-only.
pimNeighborMode 1.3.6.1.3.61.1.1.3.1.5 Yes, but read-only.