Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) - Manual (Page 421)

Unified IP MIB Reference 393
53-1002549-02
IPv4 ACL table
snAgAclPriorityForce
brcdIp.1.2.2.15.2.1.26
Syntax: Integer Read-write Indicates the priority that is being forced on the outgoing
packet. This parameter allows you assign packets of
outgoing traffic that match the ACL to a specific
hardware-forwarding queue, even though the incoming
packet may be assigned to another queue.
Valid values:
•
qosp0(0)
•
qosp1(1)
•
qosp2(2)
•
qosp3(3)
•
Not defined(4)
Default: Not defined(4)
NOTE: This option applies only to 10 Gigabit Ethernet
modules.
snAgAclPriorityMapping
brcdIp.1.2.2.15.2.1.27
Syntax: Integer
NOTE: This is not supported on the
Brocade MLXe, Brocade
NetIron MLX, Brocade NetIron
XMR, Brocade NetIron CES,
and Brocade NetIron CER
series devices. It is also not
supported on the FastIron
devices.
Read-write Indicates the priority of the incoming packet to be
matched. This option maps the packet’s 802.1p value. It
does not change the packet’s forwarding priority through
the device nor does it mark the packet.
Valid values: 0 – 8
Default: Not defined(8)
snAgAclDscpMarking
brcdIp.1.2.2.15.2.1.28
Syntax: Integer Read-write Indicates the DSCP marking of a packet that will be
matched.
Valid values: 0 – 64
Default: Not defined(64)
NOTE: This option applies only to 10 Gigabit Ethernet
modules.
snAgAclDscpMapping
brcdIp.1.2.2.15.2.1.29
Syntax: Integer Read-write Indicates the DCSP value of the incoming packet value to
be matched.
Valid values: 0 – 64
Default: Not defined(64)
NOTE: This option applies only to 10 Gigabit Ethernet
modules.
Name, OID, and syntax Access Description