Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) - Manual (Page 587)

Unified IP MIB Reference 559
53-1002549-02
Chapter
55
PIM MIB Definition
In this chapter
• Common PIM objects . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 559
• PIM virtual interface table . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 560
• PIM neighbor table . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 561
• PIM virtual interface statistics table . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 562
• PIM-SM . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 564
Common PIM objects
NOTE
The following section describes the Protocol Independent Multicast (PIM) MIB objects that are
supported on the Unified IP MIB. The following objects in this chapter are not supported on the
Brocade NetIron MLX, Brocade MLXe, Brocade NetIron XMR, Brocade NetIron CES, and Brocade
NetIron CER series devices.
The following table presents objects that are common to all PIM interfaces.
Name, OID, and syntax Access Description
snPimEnable
brcdIp.1.2.9.1.1
Syntax: RtrStatus Read-write Determines if PIM is enabled on this Layer 3 Switch:
•
disabled(0)
•
enabled(1)
Default: disabled(0)
The remaining objects apply only if this object is set to
enabled(1).
snPimNeighborRouterTimeout
brcdIp.1.2.9.1.2
Syntax: Integer Read-write Specifies the number of seconds the PIM Layer 3 Switch
waits before it considers a neighbor to be absent. Absence
of PIM hello messages from a neighboring Layer 3 Switch
indicates that a neighbor is not present.
Valid values: 60 – 8000 seconds
Default: 180 seconds
snPimHelloTime
brcdIp.1.2.9.1.3
Syntax: Integer
NOTE: This object is not supported
on the Brocade NetIron MLX,
Brocade MLXe, Brocade
NetIron XMR, Brocade NetIron
CES, and Brocade NetIron CER
series devices.
Read-write Specifies the number of seconds that periodic hellos are
sent out on PIM interfaces. Layer 3 Switches use hello
messages to inform neighboring Layer 3 Switches of their
presence.
Valid values: 10 – 3600 seconds
Default: 60 seconds