Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) - Manual (Page 317)

Unified IP MIB Reference 289
53-1002549-02
NetFlow Export
Name, OID, and syntax Access Description
snNetFlowAggregationTable
brcdIp.1.1.3.18.3 None The NetFlow Export aggregation table
snNetFlowAggregationIndex
brcdIp.1.1.3.18.3.1.1
Syntax: Integer Read-only Specifies what information is used to aggregate the flow:
•
as(1) – Autonomous system scheme uses the input
and output interfaces and the source and
destination BGP4 AS.
•
protocolPort(2) – IP and application port source and
destination IP, and source and destination TCP or
UDP port numbers.
•
destPrefix(3) – Destination prefix scheme uses
output interface, destination network mask and
prefix, and destination BGP4 AS.
•
sourcePrefix(4) – Source prefix scheme uses the
input interface, source network mask and prefix,
and source BGP4 AS.
•
prefix(5) – Source and destination prefix scheme
uses the input and output interfaces, source and
destination network masks and prefixes, and source
and destination BGP4 AS.
snNetFlowAggregationIp
brcdIp.1.1.3.18.3.1.2
Syntax: IpAddress Read-write The IP address of the NetFlow Export aggregation
collector.
snNetFlowAggregationUdpPort
brcdIp.1.1.3.18.3.1.3
Syntax: Integer Read-write The UDP port of the NetFlow Export aggregation collector.
snNetFlowAggregationSourceInterface
brcdIp.1.1.3.18.3.1.4
Syntax: Integer Read-write Shows the source port to export the NetFlow Export
aggregation packets:
•
A valid port number – The port configured to be the
source port.
•
0 – No source port specified. The port connected to
the collector is the source port.
snNetFlowAggregationNumberOfCache
Entries
brcdIp.1.1.3.18.3.1.5
Syntax: Integer32 Read-write Shows the maximum number of aggregated flows that
the aggregation cache can contain.
snNetFlowAggregationActiveTimeout
brcdIp.1.1.3.18.3.1.6
Syntax: Integer32 Read-write Shows the maximum time in minutes that an active flow
can remain in the NetFlow Export aggregation cache.
Valid values: 1 – 60 minutes
Default: 30 minutes
snNetFlowAggregationInactiveTimeout
brcdIp.1.1.3.18.3.1.7
Syntax: Integer32 Read-write Shows the maximum time in seconds that an inactive
flow can remain in the NetFlow Export aggregation
cache. The object can have a value from 10 through 600
seconds.
Default: 15 seconds