Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) - Manual (Page 211)

Unified IP MIB Reference 183
53-1002549-02
Chapter
7
Switch Group Configuration
In this chapter
• Switch group configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 183
Switch group configuration
The switch group configuration table is supported on the FastIron devices.
Name, OID, and syntax Access Description
snSwGroupOperMode
brcdIp.1.1.3.1.1
Syntax: Integer
NOTE: This object is not
supported on the
Brocade MLXe
router, Brocade
NetIron MLX,
Brocade NetIron
XMR, Brocade
NetIron CES, and
Brocade NetIron
CER series devices.
Read-write Indicates if switch ports have VLANs defined:
•
noVLan(1) – All switch ports with no port VLANs and no tag
assigned.
•
vlanByPort(2) – All switch ports with basic port-based VLANs.
snSwGroupIpL3SwMode
brcdIp.1.1.3.1.2
Syntax: Integer Read-write Indicates if the Layer 3 IP switch is enabled for the switch group:
•
disabled(0)
•
enabled(1)
snSwGroupIpMcastMode
brcdIp.1.1.3.1.3
Syntax: Integer Read-write Indicates if the IP multicast pruning mode is enabled for the switch
group:
•
disabled(0)
•
enabled(1)
snSwGroupDefaultCfgMode
brcdIp.1.1.3.1.4
Syntax: Integer
NOTE: This object is not
supported on the
Brocade MLXe
router, Brocade
NetIron MLX,
Brocade NetIron
XMR, Brocade
NetIron CES, and
Brocade NetIron
CER series devices.
Read-write Indicates if the switch group contains a default configuration. If the
default configuration is overwritten, the state will change to
non-default:
•
default(1) – Has a default configuration.
•
nonDefault(2) – Has a non-default configuration.