Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) - Manual (Page 748)

720 Unified IP MIB Reference
53-1002549-02
General traps for the Brocade NetIron devices
1. Configure a RMON alarm with an ID of 1 that checks for snAgGblCpuUtil1MinAvg every 300
seconds. In every sample, check if the CPU utilization fall exceeds 50 percent. If it does, send
an event(id 1) with Tom. The event trigger is re-armed, when the falling-threshold value falls
below 45 percent.
Brocade(config)# rmon alarm 1 snAgGblCpuUtil1MinAvg.0 300 absolute
rising-threshold 50 1 falling-threshold 45 65535 owner Tom
2. Configure a RMON event with an ID of 1, which sends a SNMP trap that contains the
community string "public", some description, and owner Tom whenever CPU utilization exceeds
50 percent.
Brocade(config)# rmon event 1 description "CPU Utilization exceeds 50%" trap
public owner Tom
General traps for the Brocade NetIron devices
The following table presents the general traps for the Brocade NetIron MLX, Brocade MLXe,
Brocade NetIron XMR, Brocade NetIron CES, and Brocade NetIron CER series devices.
Trap name and number Varbinds Severity Description and trap message
snTrapIfIndexAssignmentC
hanged
brcdIp.0.172 snAgGblTrapMessage Informational The SNMP trap is generated when the
interface index (ifIndex) assignment for a
physical interface is changed.
Sample trap message:
System: IfIndex assignment was
changed
snTrapModuleStatusChang
e
brcdIp.0.176 snChasUnitIndex,
snAgentBrdIndex,
snAgentBrdModuleSt
atus, and
snAgGblTrapMessage Notification The operational state of a module is
changed. The management entity receiving
the notification can identify the module and
the event by referencing snChasUnitIndex,
snAgentBrdIndex, and
snAgentBrdModuleStatus.
If the module is down, the
snAgGblTrapMessage varbind contains a
text string that describes the cause.
If the module is up, nothing is displayed for
snAgGblTrapMessage.
Sample trap message:
For module up: System: Module up in
slot
For module down: System: Module
down in slot ,
reason
For standby MP up: System: Standby
Management Module was ready
For standby MP down: System: Standby
Management Module was down,
reason . Error Code